Another good technique that is used in the Industry is: Failure Mode Effects Analysis (FMEA) This technique analyses the outcomes of a failing project. First you establish the failure modes, then risk...

In personal experience, the design matrix is the most important part of the risk management analysis. The way it was done in a job I had, was by how much money the owner of the company was going to ma...

Hello everyone, I have noticed how Dr. Simon keeps pointing out to importance of taking minutes in all the meeting of the team. I never really thought of how important they are. Before this, when I wa...

I agree with most of the challenges mentioned above by my classmates. However I have to point out that the main two challenges(In my opinion) should be safety issues and communication problems between...

Hello everyone, I hope everything is going well. Dr. Simon mentioned in the lecture that you during the deign verification and validation phase, the engineer is supposed to kind of "make up a test." I...

The whole team is in charge of launching a product to a target customer. You gotta to have certain a target customer, people who are willing to use the product. The project manager would then put toge...

The timeline done by the project management would be significantly changed. A poor product would bring down the credibility of the company and it would put in risk the safety of the patients (Addition...

The main reason why Design controls are useful is because they test the quality, liability of the product. This would make sure that the clients do no get affected in a bad way by it. On the same way,...